Lectrosonics SMWB Wideband Beltpack Transmitter / Recorder C1 614.400-691.175MHZ

Press and move to zoom

Mouse over image to zoom

Lectrosonics SMWB Wideband Beltpack Transmitter / Recorder C1 614.400-691.175MHZ

Name: Lectrosonics SMWB Wideband Beltpack Transmitter / Recorder C1 614.400-691.175MHZ
Brand: Lectrosonics
SKU: LEC.SMWB/C1
Price: 3214.00 AUD
Availability: InStock

Lectrosonics

Product code : LEC.SMWB/C1

$ 3,214.00 /Each

Tell a Friend

Lectrosonics SMWB Wideband Beltpack Transmitter/Recorder

To meet the demand for both extended operating range and extended battery life, the “WB” series SM transmitters offer selectable output power of 25, 50 and 100 mW. With higher power output, the operating range is improved at the expense of battery life. When range is not an issue, a lower power level can be used to extend the battery life.

The transmitters offer hands-free setup and adjustment using audible tones. They can be put to sleep to conserve battery power during setup while buried inside costuming, then awakened for normal operation when the production begins. Other features include input gain adjustment in 1 dB increments over a 44 dB range and adjustable low-frequency audio roll-off for 3 dB down points at 35, 50, 70, 100, 120 or 150 Hz to control subsonic and very low-frequency audio content.

Along with providing peerless audio quality with wide frequency response and dynamic range in Nu Hybrid mode, the technology used in the SMWB includes compatibility modes for Lectrosonics Mode 3 and IFB receivers.

DATA SHEET

QUICK START GUIDE

MANUAL

Selectable output power to maximize battery life or operating range
Ultra-lightweight, corrosion resistant housing
Water resistant seals for use in damp environments
LCD interface with lockout option
Programmable compatibility modes for use with a wide variety of different receivers
Servo Bias input circuitry
IR (infrared) port for fast setup
Covers 2 frequency blocks
Update firmware in the field via Micro SD card reader
Alternate use as a recorder on an internal microSDHC memory card

Operating Frequencies C1: 614.400 to 691.175 MHz

Channel Spacing Selectable between 25 or 100 kHz

RF Power Output Switchable among 25, 50 and 100 mW

Compatibility Modes Digital Hybrid Wireless (NU Hbr), 200 Series, 100 Series, Mode 3, Mode 6, IFB

Pilot Tone 25 to 32 kHz; 5 kHz deviation (digital hybrid mode)

Frequency Stability ± 0.002%

Deviation ± 75 kHz maximum (digital hybrid mode)

Spurious Radiation Compliant with ETSI EN 300 422-1

Equivalent Input Noise -125 dBV, A-weighted

Input Level If set for dynamic mic: 0.5 to 50 mV before limiting, greater than 1 V with limitingIf set for a lavalier mic: 1.7 to 170 uA before limiting; greater than 5000 uA (5 mA) with limiting

If set for line-level input: 17 mV to 1.7 V before limiting; greater than 50 V with limiting

Input Impedance Dynamic mic: 300 Ohms

Lavalier: Input is virtual ground with servo adjusted constant current bias

Line level: 2.7 kOhms

Input Level Soft limiter, 30 dB range

Bias Voltage Fixed 5 V at up to 5 mA; selectable servo bias for any electret lavalier (2 or 4 V)

Gain Control Range 44 dB; panel mounted membrane switches
Modulation Indicators Dual bicolor LEDs indicate modulation; -20, -10, 0, +10 dB referenced to full modulation

Controls Control panel with LCD and 4 membrane switches

Low Frequency Roll-Off Adjustable from 35 to 150 Hz

Audio Frequency Response 35 Hz to 20 kHz, ±1 dB

Signal to Noise Ratio Off: 103.5 dB (no limiting); 108.0 dB (with limiting)

Normal: 107.0 dB (no limiting); 111.5 dB (with limiting)

Full: 108.5 dB (no limiting); 113.0 dB (with limiting)

THD 0.2% typical (400 Series mode)

Audio Input Jack Switchcraft 5-pin locking (TA5F)

Accessories visible on product image are not included

Please be aware that John Barry has multiple warehouse locations in different states.

If you wish to purchase in store, to avoid disappointment, please confirm the availability of the product at your local John Barry prior to visiting.

Alternatively, orders placed online by 2pm AEST are typically dispatched same day, if ordered online.

If your product is on backorder, please contact us for an ETA.

Shipping is done via Startrack Express or Australia Post eParcel service and tracking advice will be provided once shipped.

For more information, please visit our Shipping Policy.

John Barry Sales offers the same the warranty conditions as scheduled by the product manufacturer.

Should you have any questions regarding our equipment warranty conditions, please contact us

John Barry will happily exchange a product sold to you that does not match the description on our website, or if the product is not of an acceptable quality or condition for use.

John Barry reserves the right under Australian Consumer Law to refuse a request for an exchange or refund on all final sale items, if you have misused/mishandled the product, or if you have simply changed your mind. Please visit our Refunds & Returns policy page for further information.

My Cart - Quick Order

Lectrosonics SMWB Wideband Beltpack Transmitter / Recorder C1 614.400-691.175MHZ

Lectrosonics SMWB Wideband Beltpack Transmitter/Recorder

Your Browsing History